Model NO. | EN source |
Production Scope | Parts Production Line |
Cylinder Specification | Inner Tank/Outer Tank |
Model specification | L1500/L2000/L2500/L3000/L3200mm |
Rated voltage | 380VAC 50HZ |
Rated power | 1.5KVA |
After-sales Service | 3-Year Warranty |
01 Product Introduction:
The device use for solar water heater tank tube hole to make dabber on the two sides, Will the solar water heater inside bucket of vacuum tubes hole in a plane, make the vacuum tube hole 2-3 points increased strength, in the operation not make the pipe hole deformation. It is a part of essential equipments in solar water heater manufacturing industry.
02 Product Features:
This equipment is made by welding steel plate and other steel.
The device adopts compressed air through the cylinder up and down as pressure power.
The equipment adopts simple lock device through the cylinder up and down. Cylinder is tightly fasten to work position during working, and to loosen locking device of end work. After finishing those things, it can draw out workpiece.
The front of cylinder puts into device and moves to the localization slot during working, then you can press the top and bottom key of cylinder to pressuring cylinder and the muscle guide tightly. Then, starting motor power moves pressure roll to achieve the purpose of molding.
03 Working Condition:
Barrel diameter: 310—600mm
Working thickness: ≤2.5mm
Maximum working length: L=3000mm
Material: pearl plate、aluminizing zinc、stainless steel、Fluorine titanium plate etc
04 Technical Parameters:
Model specification: L1500/L2000/L2500/L3000/L3200mm
Rated voltage: 380VAC 50HZ
Rated power: 1.5KVA
Height/width: according to customer requirements, if no special requirements, according to conventional production requirements.
Compressed air pressure: 0.45mMpa
Electric part warranty period one year.
Pneumatic element: pneumatic element made by AIRTAC
The device use for solar water heater tank tube hole to make dabber on the two sides, Will the solar e water heater inside bucket of vacuum tubes hole in a plane, make the vacuum tube hole 2-3 points increased strength, in the operation not make the pipe hole deformation, reduce scrap, sheet bending place does not produce indentation, need not special mold, use cost is low, installation and operation are convenient, has the very high plane degrees.