Internal lining system:1. Enamel machineSize requirement: Φ 400 × H400-1000mm
Design requirement:
1) Stainless steel use SUS201
2) The equipment consists of feeding, recharging station, rack, motor, transmission mechanism, jacking cylinder, solenoid valve for controlling cylinder, control box and control circuit. The equipment is lined with three single gallbladder at the same time.
3) Selection of a large caliber diaphragm pump for transporting glaze slurry
4) Electrical control: diaphragm pump pneumatic control; full automatic (PLC) control for different sizes of workpieces set different operating procedures to ensure the best enamelling quality.
5) Capacity per unit: 40-50 units / hour (40-60L / h)
6) 2.6-3m/min(0.6-0.8mpa/㎝²)
Compressed air consumption: 2.6-3m/min (0.6-0.8mpa/)
2. Open bucket2.1 BarrelSize: φ600×H1300mm
Material: 2.0mm thick SUS304 stainless steel
Skeleton: section steel
Discharge port: 2 inch stainless steel tube +valve
2.2 Agitator Form: motor stirring
Mixing motor and reduce:2.2kw
Impeller: SUS304 stainless steel
Adopt a large 2 "diaphragm pump to transport the glaze slurry
3. Filter vat3.1 BarrelSize: φ600×H1300mm
Material: 2.0mm thick SUS304 stainless steel
Skeleton: section steel
Discharge port: 2 inch stainless steel tube + valve
3.2 AgitatorForm: using motor stirring
Mixing motor and reduce:2.2kw
Impeller: SUS304 stainless steel
3.3 FilterMotor and reducer: fixed speed
Filter: stainless steel mesh
Skeleton: section steel
Machine Photo: